Tips to be a Successful Septic Tank Owner
The average household septic tank system should be inspected at least every three years by a professional septic tank company. Residential septic tanks are typically pumped every three to five years.
Four major factors influence the frequency of septic tank pumping:
•Size of Household
•Total wastewater generated
•Volume of solids in wastewater
•Size of septic tank
What happens when a septic tank company is coming to inspect your septic tank:
When you call a Union City septic tank company, they will inspect for leaks and examine the scum and sludge layers in your septic tank.
It is important to keep maintenance records on the work performed on your septic tank system.
Your septic tank includes a T-shaped outlet which prevents sludge and scum from leaving the septic tank and traveling to the drainfield area. If the bottom of the scum layer is within six inches of the bottom of the outlet, or if the top of the sludge layer is within 12 inches of the outlet, your septic tank needs to be pumped.
To keep track of when to pump out your tank, keep a diary of the sludge and scum levels found by the septic professional.
The licensed plumbing company should note repairs completed and the septic tank condition in your system’s service report. If other repairs are recommended, hire a Union City professional septic tank company soon.
Septic Tanks - Ensuring Water Quality
An anaerobic septic system is generally what most people who have septic system already have installed. It's been the most popular type partly because there has been so little to compete with it. They don't cost that much to install, they are relatively simple to maintain, and it's been accepted that this is the standard for residential systems. While the private sector has certainly embraced the anaerobic system, municipalities do not use these at all.
An anaerobic septic system breaks down waste product at a rather slow and inefficient rate. When considering the residential use of a septic system this could be found to be acceptable. By the consistent standard use and the fact that one household would have to work pretty hard to fill up the system there has been little question as to the efficiency of the system. Municipal use of such systems simply doesn't exist. These systems can not handle the large volumes of waste that they encounter on a daily basis. Thus, industrial systems are aerobic.
Anaerobic systems also tend to discharge a foul, repugnant sludge that is thick and slimy. It turns into what is known as a bio-mat. Aside from being a hazard to the environment this is also what eventually backs up the system and requires costly repairs. It may only happen once every 20 years, but the system will eventually stop working properly because of the bio-mat. The waste product that these septic system leave behind is considered to be an environmental hazard and is generally unhealthy to live around. The aerobic systems are starting to win favor among residential units because they tend to counteract all of the general negatives that the anaerobic systems offer.
Pressure Jetting Services
Ultra high pressure jetting can operate at pressures of around 2,750 bar. That's about 40,000 pounds per square inch, which is a serious amount of pressure. High pressure hydro blasting units can be powered by a diesel engine or an electric motor. They can be dual purpose and capable of switching from high pressure to ultra pressure by changing the pump that is being used.
The uses of UHP and HP hydro blasting are many and varied. They range from tank and vessel cleaning to surface preparation, as well as cold cutting. They are used in hazardous areas where excessive heat or the possibility of a spark could be dangerous due to gases or other substances presenting a potential risk.
The equipment should always be maintained to the best working order possible. This can be made possible through regular maintenance routines and inspections where any faulty or worn parts can be replaced if required.
Regular maintenance coupled with up to date training for the operators of the ultra high pressure jetting equipment and machinery is the best way to ensure a high level of safety for everyone involved.